Operating The Axiocam Mrc5 On A Notebook With Onboard Firewire Interfaces; Connecting The Camera To The Notebook - Zeiss AxioCam MRc5 Installation Reference Manual

Installation of the AxioCam MRc5
Operating the AxioCam MRc5 on a notebook
with onboard FireWire interfaces

Connecting the camera to the notebook

Lay the data cable carefully between the camera and the
notebook. Make sure that the cable is a safe distance from hot
light sources on the microscope, to prevent it being damaged by
heat.
To ensure the efficient use of energy resources, the FireWire slots
on the notebook are not designed to supply power to peripheral
devices. A FireWire hub should therefore be used to supply power
to operate the AxioCam MRc5 on a notebook.
The following components are required:
FireWire hub with power supply (order number: 000000-0452-376)
6-pin to 6-pin FireWire cable (supplied with the AxioCam MRc5) to
connect the AxioCam MRc5 to the FireWire hub.
4-pin to 6-pin FireWire cable (supplied with the FireWire hub) to connect
the FireWire hub to the notebook.
16 B 48-0028 e 10.2003