KitchenAid OUTDOOR COOKING – GRILL Instructions Manual page 3

6. Use adjustable wrench to remove brass elbow, extension
pipe and LP hose regulator from manifold fitting.
B
D
A. Manifold
B. Brass elbow (supplied) and extension pipe
C. Rear of grill
D. Gas pressure regulator/hose assembly
7. Use adjustable wrench to install brass elbow (supplied) to
manifold.
8. Apply pipe sealant to ¹⁄₂" NTP threads of brass elbow. Use
pipe thread sealant that is certified for use with LP gas.
NOTE: The arrow on the regulator must be pointing toward
the manifold pipe.
9. Use pipe wrench to install the convertible regulator. Brass
cap to be facing up.
A
A. Brass elbow
B. Convertible regulator
A
C
B
10. To make sure the regulator is set for Natural gas, remove
brass cap on convertible regulator.
11. Examine the stem on the brass cap. If the letters "NAT" are
not showing on the end of the plastic stem farthest away from
the brass cap, remove stem from cap, turn it over and snap
stem back into the cap so the letters "NAT" are at the end of
the stem farthest away from the brass cap.
12. Use adjustable wrench to reinstall cap onto regulator.
Change the main grill burner valve orifices
1. Manually remove all of the grates, sear plate, and burners.
2. Remove the 2 screws that hold the burner in place. Remove
gas burner from the grill.
A. Two screws
3. Use 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifices from the end of the gas valves.
A. Grill burner orifice
A
A
3