Table of Contents
Advertisement
Diesel Cleaning Procedures
6.
Verify that Mixture, Priming, and Diesel Setup Procedures above have been
completed before continuing.
Press
7.
SERVICE SELECTOR SWITCH
switch on after turning
starts.
Press and hold the
8.
pressure can be checked by observing the
for leaks and correct as necessary.
9.
Once the pressure has stabilized, release the
Check for fuel leaks and correct as necessary.
10.
Once the unit and engine are running, the run time can be adjusted. The default run time is 60
minutes.
Soak Mode
Use of the Soak Mode Cycle improves fuel system cleaning results, but it may be
bypassed if a shorter service is desired.
5.
After
minutes of operation or half of the run time, whichever is less; a
20
initialized.
6.
Shut down engine. Then press off the unit's
down the pump and fuel supply to engine, so it is very important that engine be shut
down first.
7.
Let fuel mixture soak in engine for at least 15 minutes. Turn
the
switch on. Press and hold the
ON/OFF
pressure.
8.
Continue on with the cleaning mode. Reset the
was initialized. Restart the engine. The cleaning cycle will continue for the
Soak Mode
remaining run time.
Additional Soak Cycles can be initiated by repeating
steps 2 through 4 as many times as needed.
to
past five minutes. NOTE: Alarm will sound until pump
TIMER
switch. The unit will start and the pressure should rise. The
START/RUN
NOTE
DIESEL FUEL SYSTEM
gauge.
FUEL PRESSURE
switch
START/RUN
switch. NOTE: This will shut
ON/OFF
TIMER
switch to restart the unit and build
START/RUN
to the time last shown before the
TIMER
and press the
ON/OFF
Check all connections
Then start the engine.
.
can be
Soak Mode
past five minutes. Turn
Advertisement
Table of Contents
