Throttle Body Injection (Tbi) Setup Procedure - Carbon MCS-352 Service Manual

Dual system for gasoline (petrol) and diesel engines
Table of Contents

Advertisement

Throttle Body Injection (TBI) Setup Procedure

Follow the steps below to connect the unit to the vehicle's fuel system. Make sure the
vehicle has at least 1/8 tank of fuel before beginning this process.
1.
Start the vehicle and allow the engine to reach normal operating temperature
Do not perform the setup or cleaning process if the
vehicle's engine oil or coolant level is low.
If necessary, add oil and/or coolant to the vehicle.
2.
Turn the vehicle OFF
3.
Turn the
Gasoline (Petrol)
completely open. Verify that the
4.
Attach the unit to the vehicle's battery by connecting the
battery terminal and the
possible. Press the SERVICE SELECTOR switch to the side with Gasoline (Petrol) FUEL
SYSTEM SERVICE.
5.
Remove the vehicle's gas cap to relieve fuel tank pressure.
6.
Disconnect the vehicle's fuel lines from the throttle body. There are now four open ends to
work with:
Pressure Line
From the tank to the throttle body.
7.
Add a pre-mixed gasoline and detergent mixture to the right side (gasoline /petrol) reservoir.
When filling the reservoir, add
See page 3-3 for alternate filling method (Refer to page 3-2 for the proper ratios.)
cylinder.
IMPORTANT
when normal operating temperature has been reached.
PRESSURE
REGULATOR
switch is turned off
ON/OFF
battery clip to a solid ground point as far from the battery as
black
Return Line
1 oz. (30 ml.) of Detergent to 3 oz. (90 ml.) gasoline per
counterclockwise until the regulator is
.
battery clip to the positive (
red
From the throttle body to the tank.
.
)
+

Advertisement

Table of Contents
loading

Related Products for Carbon MCS-352

Table of Contents