Table of Contents
Advertisement
Carburetor Cleaning Procedure
Follow the steps below to circulate the fuel/detergent mixture through the vehicle's
carburetor.
Verify that
1.
Carburetor Setup Steps 1- 8
Refer to the vehicle's service manual for the manufacturer's recommended pressure.
2.
Press and hold the
5.
Turn the
6.
Gasoline (Petrol) PRESSURE REGULATOR
gauge reads
4 PSI,
Release the
7.
START/RUN
8.
Start the vehicle
•
When the cleaning process is halfway completed, step on the vehicle's accelerator
quickly three or four times.
When the run time expires, the cleaning is complete. The unit will automatically shut off and
9.
the alarm will sound. Press off the
10.
Turn OFF the vehicle's engine.
Turn the
11.
Gasoline (Petrol) PRESSURE REGULATOR
any residual pressure.
Wrap a shop towel around pressure fittings
before
residual fuel spray.
Disconnect the battery leads, hoses, and adaptors. Return the vehicle's fuel system to its
12.
normal operating condition by re-connecting the vehicle's fuel lines.
Adjust
knob for 30 minutes. (Run time may be adjusted
3.
TIMER
depending on the condition of the vehicle's fuel system.)
Press the
4.
ON/OFF
switch.
START/RUN
or the equivalent of the manufacturer's recommended specifications.
switch.
Check all connections for leaks.
to begin the fuel system cleaning process.
Then, maintain 1500 – 2000 RPM for 30 seconds.
ON/OFF
IMPORTANT
disconnection
above have been completed.
switch on.
clockwise until the
switch.
counterclockwise on the unit to release
to
protect
SEE NEXT PAGE
Fuel PRESSURE
against
Advertisement
Table of Contents
