Table of Contents
Advertisement
Carburetor Setup Procedure
Follow the steps below to connect the unit to the vehicle's fuel system. Make sure the
vehicle has at least 1/8 tank of fuel before beginning this process.
Start the vehicle and allow the engine to reach normal operating temperature
1.
Do not perform the setup or cleaning process if the
vehicle's engine oil or coolant level is low.
If necessary, add oil and/or coolant to the vehicle.
Disconnect the vehicle's fuel line at the carburetor inlet or at the fuel pump outlet. There
6.
should now be two open ends to work with:
•
One coming from the fuel pump.
•
One going into the carburetor.
Add a pre-mixed gasoline and detergent mixture to the right side (gasoline /petrol) reservoir.
7.
When filling the reservoir, add
See page 3-3 for alternate filling method (Refer to page 3-2 for the proper ratios.)
cylinder.
IMPORTANT
2. Turn the vehicle OFF
reached.
Turn the
3.
Gasoline (Petrol) PRESSURE REGULATOR
until the regulator is completely open. Verify that the
turned
.
off
Attach the unit to the vehicle's battery by connecting the
4.
to the positive (
) battery terminal and the
+
ground point as far from the battery as possible. Press the SERVICE
SELECTOR switch to the side with Gasoline (Petrol) FUEL
SYSTEM SERVICE.
Remove the vehicle's gas cap to relieve fuel tank pressure.
5.
1 oz. (30 ml.) of Detergent to 3 oz. (90 ml.) gasoline per
when normal operating temperature has been
black
.
counterclockwise
switch is
ON/OFF
battery clip
red
battery clip to a solid
Advertisement
Table of Contents
