Bayer HealthCare Contour Plus User Manual page 8

8
3. Insert the lancet firmly
into the lancing device
until it comes to a full
stop. This will re-set
the device. You can
also pull and release
the re-setting handle.
4. Twist off the round
protective lancet cap.
Save it for disposing
of the used lancet.
5. Replace the grey
endcap.
6. The puncture depth
depends on the
endcap setting
and the amount of
pressure applied to
the puncture site.
Rotate the endcap dial
to adjust the puncture
depth.
Inserting the Test Strip
1. Remove a C P
®
ONTOUR LUS
from the bottle. Tightly close the
bottle lid immediately after you have
removed the test strip.
This will turn the meter on.
An image of a test strip with
a flashing blood drop
will appear letting you know
the meter is ready to test.
HINT: After the test strip is inserted, if you do not
apply blood to the test strip within 3 minutes,
the meter will turn off. Remove the test strip and
reinsert it to begin a test.
test strip est strip
e the
r you have
2. Hold the test strip
with the grey square
end facing up toward
the meter.
3. Insert the grey square
end firmly into the
test strip port until the
meter beeps.
9