Function 1: System Parameters; Function 11: Initialize; Functions 12 And 13: Installer And Administrator Passwords - ESI IVX C-Class Installation Manual

IVX C-Class Installation Manual

Function 1: System parameters

Function 11: Initialize

This function will return all components and software to their initial state. Initialization will erase all data
and custom recordings.
Important notes: Always initialize the system before initial programming for a new installation.
You must confirm the command to initialize, when prompted, by entering the
Installer password.
Be sure to set the time and date (Function 14) before initializing.
System initialization will take approximately one minute to complete. When completed, the phone's
display will return to the idle state. You must then re-access Programming Mode by following the
steps described earlier (see page C.3).

Functions 12 and 13: Installer and Administrator passwords

These functions will display the existing password and prompt for entry of a new password. The
passwords can be 2–8 digits long, followed by #. The Installer can change either the Installer or
Administrator Password. Only those functions listed in the Administrator manual can be
programmed via the Administrator Password. The default passwords are:
Installer Password (Function 12)
Administrator Password (Function 13)
Notes: Be sure to write down the new passwords, store them in a safe place and give the new Administrator's
Password to the Administrator.
Accessing user station programming
Should a user forget his password or if an employee leaves the organization, this feature allows the
Installer or Administrator to enter a user's station programming and operate within it as if he were the
user. From the user's station, enter the Installer or Administrator password when the system prompts
for the user password.
Example: From station 105, entering 7 8 9 # or 4 5 6 # instead of the user password (1 0 5 #) will enter the
station's user programming. (Default passwords shown for this example).
= 7 8 9
= 4 5 6
Function 1: System parameters
D.1