Table of Contents
Advertisement
Setting up
9
Height adjustment of the hot wedge
.01.02
● Loosen screw 1 and adjust stop 2 so that the hot wedge 3, when disengaged, is about
● Loosen screw 4 and adjust pull-spring so that the sealing body rests with only light
● Loosen screws 5 and re-position the entire suspension unit, until the hinges are in a
● Tighten screws 5.
9 - 2
Fig. 9 - 02
Switch the machine off and let it cool down!
Danger of burns if the hot wedge is touched!
In the heat-sealing position, the tip of the spring-mounted hot wedge 3 should
be a distance above the bottom feed roller corresponding to the thickness of
the material to be sealed.
2 mm below the sealing position.
pressure against stop 2.
horizontal position.
5
1
2
4
3
Advertisement
Table of Contents
