Table of Contents
Advertisement
Installation Outline
The following procedures, diagrams, and instructions must be followed precisely to avoid damage to the
control panel and its associated equipment. Reliability depends to a great extent upon proper installation and
maintenance.
Cabinet - Mount the cabinet and draw all field wiring through the knockouts provided. NOTE: Use only one
of the two knockouts provided on the bottom of the cabinet. The batteries will cover the other knockout.
Main Power Supply - Mount the Main Power Supply to the cabinet as illustrated in Figure 3-1. Do not wire
anything at this time!
Transformer - Mount the Transformer to the cabinet as illustrated in Figure 3-1.
Audio Visual Supplies - If an optional AVPS-24F is to be employed, mount it to the cabinet (see Figure 3-1).
Audio Visual Cables - If employing an AVPS-24F, connect the AVPS Trouble Cable. Connect the Auxiliary
Bell Power Harness to the AVPS–24F. Refer to Section Five to connect these cables.
Section Three:
Installation
The control panel's modules communicate with the
CPU through a common ribbon cable connection.
Sensiscan 200 15032 Rev C1 11/1/96 P/N 15032:C1
13
Advertisement
Table of Contents
