Setting The Temperature; Using The Emergency Switch; Switching Off The Cooler; Defrosting The Cooler - Waeco CF-1 Instruction Manual

CoolFreeze
6.6

Setting the temperature

CF-18
➤
Set the cooling temperature with the temperature controller
(Fig.
CF-25, CF-35, CF-40, CF-50, CF-60
➤
Press the "SET" button (Fig.
➤
Use the "UP +" (Fig.
page 5) buttons to select the cooling temperature.
✔
The cooling temperature appears in the display for a few seconds.
The display flashes several times and then the current temperature
is displayed again.
6.7

Using The Emergency Switch

➤
The emergency override switch (Fig.
located in the connection panel.
➤
For normal operation the switch should be in the 'NORMAL USE'
position.
➤
In the unlikely event of an electronic control failure slide the Switch
to 'EMERGENCY OVERRIDE'.
NOTE: in this position the appliance will run all the time and will
therefore perform as a freezer only.
6.8

Switching off the cooler

➤
Empty the cooler.
➤
Switch the cooler off.
➤
Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤
Leave the lid slightly open. This prevents odour build-up.
6.9

Defrosting the cooler

Humidity can form frost in the interior of the cooling device or on the
evaporator. This reduces the cooling capacity. Defrost the device in good
time to avoid this.
Caution – Danger of damaging the device!
Never use hard or pointed tools to remove ice or to loosen objects
which have frozen in place.
To defrost the cooler, proceed as follows:
20
3 1, page 4).
4
4 4, page 5) once.
6, page 5) and "DOWN -" (Fig.
5 &
4 7,
6 4, page 5) is