Gateway Replacement; D.6 Gateway Replacement - Emerson Smart Wireless Gateway Reference Manual

Reference Manual
00809-0200-4420, Rev GA
Figure D-7. Network Connectivity Check
D.6

Gateway replacement

When replacing or reintroducing a Gateway in a redundant system, always connect both the
primary and secondary Ethernet connections before powering the standby Gateway. If the
Gateway is being reintroduced (i.e. it was a part of the original redundant system), it will
automatically rejoin the redundant system. If the Gateway is new or has been set to default
configuration, it will need to be paired to the current active Gateway. Navigate to Diagnos-
tics>Advanced>Redundancy Status and follow the recommended actions on that page or follow
the procedure above to pair Gateways and form a redundant system.
Setup>Network>Ethernet protocol
Appendix D: Redundancy
April 2013
81