ASL INTERCOM DAX200 Installation Manual page 11

Figure 13 DAX200 – Plug Ribbon Cable
Earthing Bar
!
!
Right and left
connector clamps
fully 'clicked' into
place over the ribbon
connector.
29.
Carefully lift the batteries into position and
secure with the strap provided as shown in
Figure 14 for DAX200, and
DAX400.
Ensure correct positioning of batteries:
!
!
DAX200: top side of batteries facing the
operator.
DAX400: front side of batteries facing the
operator.
DAX200/DAX400 – Installation Guide
Field wiring from host DAU
and other 'daisy-chained'
DAX units (if any)
16-way ribbon
cable
Figure 15
Issue: 02 complete, approved
30.
Connect
negative, and interlink) noting correct
polarity: Red=Positive, Black=Negative.
Note that the interlink cable is red.
The 24 V DC batteries can deliver very
!
!
high currents that could cause fire or
burns. Take care to avoid short-circuits of
the battery supply by tools or jewellery.
See
! !
for DAX400.
Note the orientation of the ring terminals.
Ensure correct connection of battery
leads to the charger board.
Correct
illuminate the LED located on the left of
the battery connection points on the
electronics module.
Figure 14
DAX200
DAX200
for
RED WIRE
POSITIVE
Page 11 of 28
the battery cables
Figure 14 for DAX200, and
connection of
DAX200 – Battery Connection
LED
TOP SIDE OF BATTERIES
RED WIRE
NEGATIVE
POSITIVE
(positive,
Figure 15
batteries will
BATTERY
INPUTS
RED WIRE
BLACK WIRE
NEGATIVE