Visslo F8 premier Operation Manual page 42

How to check
①
" Movement Inspection" select
②
"Head Contact Sensor Status --> 0 ON" are turned up and head is going down.
Contact sensor is OK if 4090 off
Go to next step by pressing "select"
③
"Arm Contact Sensor Status --> 0 ON" turns up and chamfer wheel is going down.
Head sensor is OK if 4090 off
Go to next step by pressing "select"
④
"Check Encoder Values ---> 0 " turns up and gauge is going down.
Checking the figures by moving gauge to left and right by hands.
It's normal if more than "3000" turns up when moved to the end of left and right.
Go to next step by pressing "select"
⑤
"Did you install a Lens? (Yes->[+], No->[-])" turns up and head goes back
to original position.
That's the MODE to check pressure by inserting pressure guage in to the middle
of head.
Pressure differs from what lens are chosen from first MENU.
When press "No->[-]" and moves to MENU mode.
8) Counter Job : Indicate the number of edged lens for each lens material
the number of polished,grooved,chamferd one too
--> > > > --
-- --
Exit
Glass
Plastic
Polica
Polish
Groove
Chamfer
Total
9) Upgrade Program
-->
Exit
Waiting . . .
turns up when you lift head up by hands.
turns up when you lift chamfer wheel down by the hands.
***** Counter Job *****
--> > > > --
-- --
-- -- -- --> > > >
-- --> > > > -- --
--> > > > --
-- --
-- --> > > > -- --
--> > > > -- -- --
--> > > > -- -- --
***** Upgrade Program *****
00000 PCS
00002 PCS
00000 PCS
00002
00000
00000