Visslo F8 premier Operation Manual page 40

* Rotation Limit : Edge as much as rotations if edging is not done
4) Regulate Bevel : Necessary compensation values for regulating beveling
--> Bevel Height Constant
Bevel Finish Position
Bevel Polish Position
CEL Frame SIZE (H/V)
CEL Frame SIZE (V)
Exit
* Bevel Height Constant : Grooving depth of bevel wheel
* Bevel Finish Position : Compensate finished beveling position
* Bevel Polish Position : Compensate finished polishing position
* CEL Frame SIZE (H/V) : Compensate whole size of celluloid frames
* CEL Frame SIZE (V) : Compensate vertical size of celluloid frames
5) Regulate Groove /Chamfer : Necessary compensation value for regulating
***** Regulate Groove & Chamfer *****
Minimum lens width for Groove
Groove Depth
Groove Position
Groove Width
Chamfer Depth
Chamfer Position
Chamfer Width
Exit
* Minimum Lens Width for Groove :
* Groove Depth :
* Groove Position : Compensate position of grooving wheel
* Groove Width :
* Groove Compensation Parameter : Compensate depth
* Chamfer Depth :
* Chamfer Position <F>, <R> : Compensate front /rear position
***** Regulate Bevel *****
beveling/chamfering
<
F >
< R >
<BVL, F>
<BVL, R>
<FLT, F>
<FLT, R>
0.98 <--
0.00
0.00
0.00
0.00
*****
***** *****
< < < < -- -- -- --
0.40
0.00
0.60
1.50
0.00
0.00
0.00
0.00
0.00
0.00