Configuring And Installing User Interface Controls; Terminating Cat-5 Cables; Installing An External Ir Sensor; Connecting Ir Sensors - Niles IntelliControl ICS Installation And Setup Manual

CONFIGURING AND INSTALLING USER INTERFACE CONTROLS

CONFIGURING USER INTERFACE CONTROLS
CAT-5 WIRING
TERMINATION DIAGRAM
The IntelliControl ICS touch screens and keypads connect
to the IntelliControl ICS Modular MultiZone Receiver via
CAT-5 cable. For the system to function properly all runs
of CAT-5 must be pulled in home-runs from the touch
screen and keypad locations to the system head end
where the IntelliControl ICS Modular MultiZone Receiver
and other system components will be located.
The runs of CAT-5 must be terminated with RJ-45 connec-
tors using the T-568A pinout confi guration as follows:
RJ-45 Plugs
IntelliControl ICS RJ-45 Pinout and checklist
Pin # Description
1 TX+
2 TX–
3 RX+
4 IR Signal
5 IR Ground
6 RX–
7 UI Power
8 UI Ground
Note: TX+ = transmit, RX+ = receive, UI = user interface.

CONNECTING IR SENSORS

Using a properly configured CAT-5 cable, connect
the IR Sensor terminal on the touch screen or keypad
to the plug-in terminal on an IR Sensor as shown.
CAUTION: These connections are different than those used from
the touch screens or keypads to the IntelliControl ICS Modular
MultiZone Receiver. Be sure to check wire configuration and con-
nections before powering up the system.
Color Code
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown
INSTALLING AN EXTERNAL
IR SENSOR
To add an IR sensor to a user interface, use the wiring
diagrams and connector detail that follow to adapt an
RJ-45 connector from a user interface to the plug-in
wire terminals on the IR sensor.
IR Sensor to Touch Screen and Keypad pinout
Pin # Color Code
1 White/Green
2 Green
3 White/Orange
4 Blue
5 White/Blue
6 Orange
7 White/Brown
8 Brown
CONTACT
IR sensor to Contact touch screen connection
(800) BUY-HIFI NILES AUDIO CORPORATION
Connector
12V
Data
Ground
Empty
Status
Empty
Empty
Empty
IR Sensor
54