Connection - Niles IntelliControl ICS Installation And Setup Manual

EXAMPLES OF INTELLICONTROL
WIRING TERMINATION DIAGRAM
The IntelliControl ICS touch screens and keypads con-
nect to the IntelliControl ICS Modular MultiZone Receiver
via CAT-5 cable. For the system to function properly all
runs of CAT-5 must be pulled in home-runs from the
touch screen locations to the system head end where
the IntelliControl ICS Modular MultiZone Receiver and
other system components will be located.
The runs of CAT-5 must be terminated with RJ-45 connec-
tors using the T-568A pinout confi guration as follows:
RJ-45 Plugs
Pin # Description
1 TX+
2 TX–
3 RX+
4 IR Signal
5 IR Ground
6 RX–
7 UI Power
8 UI Ground
Note: TX+ = transmit, RX+ = receive, UI = user interface.
Important: All CAT-5 runs must be terminated
using T-568A pinouts.
CONNECTIONS
Using a properly configured CAT-5 cable, connect
the system terminal on the touch screen to any of the
RJ-45 communication and control hub ports on the
IntelliControl ICS Modular MultiZone Receiver as shown
in the following diagrams.
USER INTERFACES
CAT-5 CONNECTION
Color Code
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown
® ICS SYSTEM CONFIGURATIONS
Contact connecting to the
Communication and Control Switch
GXR2
DISPLAY
Display Keypad connecting to the
Communication and Control Switch
GXR2
CAT-5 Cable
SINGLE
Single Keypad connecting to the
Communication and Control Switch
(800) BUY-HIFI NILES AUDIO CORPORATION
DISPLAY
System
Terminal
SINGLE
45