Niles IntelliControl ICS Installation And Setup Manual page 37

EXAMPLES OF INTELLICONTROL
IM-AUDIO INSTALLATION INSTRUCTIONS
3-30 Volt Sync
If the source component has no Video output, con-
nect the control voltage from a current sensing device
like the Niles CS-12V to Voltage Sync IN. Polarity:
TIP=+12VDC; SLEEVE=GND.
Using the Niles CS-12V Current Sensor:
The CS-12V will sense the difference in current draw
between stand-by and on for the source it is sensing.
The CS-12V will send 12V to the sync input to let the
IntelliControl ICS Modular MultiZone Receiver know that
the source is on. The IntelliControl ICS Modular MultiZone
Receiver will appropriately manage power commands for
the source component by knowing when it is on or off.
1. Plug the power cord of the source component into
the AC jack on the CS-12V.
2. Plug the power cord for the CS-12V into an
un-switched AC outlet.
3. Connect the 12V output of the CS-12V in to the
3-30V Sync IN on the IM-AUDIO.
Audio/Video Component Connections
IR Flasher
on Front
panel
Audio OUT L&R
TM-AM/FM
Module
L&R Cascade Audio
OUT to Audio IN
GXR2 Slave Chassis
IM-AUDIO Module Cards
Figure 3. IM-AUDIO A/V Hook-Up Diagram
AV Component
Video OUT
IM-AUDIO
GXR2 Master Chassis
Module
Communication
& Control Switch
IR Cascade
OUT to IR IN CAT-5 Cable
Expansion
Out to Master
® ICS SYSTEM CONFIGURATIONS
EXPANDING THE SYSTEM
EXPANDING THE SYSTEM WITH AUDIO
When using multiple chassis, connect the Left and Right
Cascade Audio OUT of the IM-AUDIO to the Left and
Right Audio IN on the IM-AUDIO Module in the same
number card slot on the Slave chassis. Up to four Slave
chassis may be used in a system.
Figure 4. Cascade Audio Connections
EXPANDING THE SYSTEM USING IR
When using multiple chassis, connect the IM-AUDIO IR
OUT on the Slave chassis to the IR IN on the IM-AUDIO
Module in the same number card slot on the Master
chassis.
Figure 5. IR Pass-Through Connections
(800) BUY-HIFI NILES AUDIO CORPORATION
(CONTINUED)
37