Im-Ipod Installation Instructions - Niles IntelliControl ICS Installation And Setup Manual

EXAMPLES OF INTELLICONTROL

IM-iPOD INSTALLATION INSTRUCTIONS

INSTALLATION
WARNING: Always turn the power OFF on the Intellicontrol
ICS Modular MultiZone Receiver and be sure the AC line
cord is disconnected to avoid damage and electrical shock
before making any connections to the IM-iPOD Module.
CAUTION: The IM-iPOD Module is susceptible to static
discharge. Be sure to use a grounding strap or touch an
earth ground prior to picking up the IM-iPOD. Handle the
card by its edges.
1. Carefully slide the IM-
iPOD Module into the
appropriate card slot.
(Refer to the GXR2
Installation Worksheet
to assure proper card
slot number.)
2. Concentrate on the
GXR2 card cage guides as you insert the module card.
3. Be sure the multi-pin connector is secured to the header
in the card cage.
4. Tighten thumbscrews. (Do not over tighten.)
Connecting The iPod
The included 30-pin cable connects an iPod to the
IM-iPOD Module. It provides bidirectional transmission
of data, control and power to the
iPod.
1. Connect one end of the included
30-pin cable to the Dock Connector
Port on the bottom edge of the iPod
(see Figure 2).
2. Connect the other end of the
cable to the IM-iPOD Module.
Figure 3. The IM-iPOD card is ready for use when the Niles logo appears.
iPod
30-pin Connector Cable
Figure 4. iPOD Connecting to the Module Card.
Guides
Figure 1. Inserting the Module Card
into the GXR2 Card Cage.
Figure 2. iPod connection
to 30-pin cable connection
on\IM-iPOD Module Card
® ICS SYSTEM CONFIGURATIONS
EXPANDING THE SYSTEM
When using multiple chassis, connect the Left & Right
Cascade Audio OUT of the IM-iPOD to the Left & Right
Audio IN on the IM-AUDIO Module in the same number
card slot on the Slave chassis. Up to four Slave chassis
may be used in a system (see Figure 7).
Figure 5. Cascade Audio Connections
Expanded Systems Diagram
Figure 6. Expanded System with Cascade Audio Connections
(800) BUY-HIFI NILES AUDIO CORPORATION
30