Battery Installation And Charging - AT&T CL84102 User Manual

Getting started

Battery installation and charging

Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the charger
when not in use. The battery is fully charged after 10 hours of continuous
See the table in the Technical specifications section on page 56
charging.
for battery operating times.
Battery indicators
The screen is blank, or
shows �lace in charger
and (flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HAND�ET X.
�tep 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert
the supplied battery
with the label THI�
�IDE U� facing up as
indicated.
CHARGE light
IM�ORTANT INFORMATION
•
•
Battery status
Battery has no or very
little charge. The handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
�tep 3
Charge the handset by placing it face forward in the charger. The
CHARGE light on the top of the handset is on during charging.
Use only the supplied rechargeable battery or replacement battery
(model BT166342).
www.telephones.att.com
1 (866) 288-4268
In Canada, dial
For more detailed instructions, refer to the online Complete user's
www.telephones.att.com/manuals.
manual at
If you do not use the handset for a long time, disconnect and
remove the battery to prevent possible leakage.
To order, visit our website at
or call
6
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place the handset in the charger
when not in use.
�tep 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
1 (800) 222-3111
.
.