Spinning; Maximum Final Spin Speed; Rinse And Interim Spin; To Omit The Final Spin (Rinse Hold) - Miele PW 6065 Plus Sluice Operating And Installation Instructions

Maximum final spin speed

Programme
Sluice High
Sluice Low
Cottons hygiene
Cottons universal
Minimum iron
Delicates
Quick wash
Woollens
Silks
Shirts
Disinfection programmes*
Kitchen linen*
Table linen*
Curtains*
Pillows*
Outerwear*
Proofing*
Denim
Towelling
Separate rinse
Starch

Spinning

* = These programmes are only
available if they have been activated
via the Settings / Supervisor level .
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart above.

Rinse and interim spin

There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed.

To omit the final spin (Rinse hold)

^ Select Rinse hold from the Extras
rpm
sub-menu. The laundry will not be
1400
spun and will remain suspended in
1400
the final rinse water. This reduces
1400
creasing if the laundry is not going to
1400
be removed from the drum immedi-
1000
ately after the end of the programme.
600
– To start the final spin:
1400
1200
The washing machine will display the
maximum spin speed possible. You
400
can select a spin speed lower than
600
this. Start the final spin by pressing
1400
the Start button.
1400
– To end the programme:
1200
400
Press the a button. The water will
1400
drain away. Press the door button a
900
again, to open the door.
800
To omit the spin between rinses and
900
the final spin
1400
1200
^ Select Without spin from the Extras
1400
sub-menu . The laundry is not spun
after the final rinse. The water will
1400
drain away and the machine will go
straight into the anti-crease stage.
Spinning
23