Troubleshooting; Operational Error Codes; Table 23.Power-Up Error Code Displays; Table 24.Operational Error Code Displays - Motorola XTS 2500 Basic Service Manual

Radio-Level Troubleshooting
Error
Code
01/02 FLASH ROM Codeplug Checksum Non-Fatal Error
01/12 Security partition Checksum Non-Fatal Error
01/22 Tuning Codeplug Checksum Non-Fatal Error
01/81 Host ROM Checksum Fatal Error
01/82 FLASH ROM Codeplug Checksum Fatal Error
01/88 External RAM FATAL Error -- Note: not a checksum failure
01/90 General Hardware Failure Fatal Error
01/92 Security Partition Checksum Fatal Error
01/93 Flashport AUTHENTIFICATION CODE failure
01/98 Internal RAM Fail Fatal Error
01/A0 ABACUS Tune failure Fatal Error
01/A2 Tuning Codeplug Checksum Fatal Error
02/10 DSP Support IC Checksum Non-Fatal Error
02/81 DSP ROM Checksum Fatal Error
02/88 DSP RAM Fatal Error -- Note: not a checksum failure
02/90 General DSP Hardware Failure (DSP startup message not received
correctly)
NOTE: If the corrective action does not fix the failure, send the radio to the depot.
Operational Error
Codes
Error Code
FAIL 001
FAIL 002
58
Table 23. Power-Up Error Code Displays
Description
During radio operation, the radio performs dynamic tests to determine if the radio is
working properly. Problems detected during these tests are presented as error codes on the
radio's display. Ann error code indicates that a problem exists and that a service technician
should be contacted. Operational error codes are listed in Table 24..
Table 24. Operational Error Code Displays
Description
Synthesizer Out-of-Lock
Selected Mode/Zone Codeplug Checksum Error
Corrective Action
Reprogram the codeplug.
Send Radio to Depot.
Send Radio to Depot.
Send Radio to Depot.
Reprogram the codeplug.
Send radio to depot.
Turn the radio off, then on.
Send radio to depot.
Send radio to depot.
Send radio to depot.
Turn the radio off, then on.
Send radio to depot.
Turn the radio off, then on.
Send radio to depot.
Turn the radio off, then on.
Turn the radio off, then on.
Corrective Action
a. Reprogram external codeplug
b. Send radio to depot
Reprogram external codeplug