Disassembly/Assembly
Universal
Connector Cover
Remove the
Universal Connector
Cover
Attach the Universal
Connector Cover
40
The universal connector cover is located on the antenna side of the radio. It is used to cover
the connector when not in use.
NOTE:
To prevent damage to the connector, shield it with the
connector cover when not in use.
1.
Insert a flat-blade screwdriver into the area between the bottom of the cover and the
slot below the connector.
Figure 23. Removing the Universal Connector Cover
2.
Hold the top of the cover with your thumb while you pry the bottom of the cover
away from the radio with the screwdriver.
1.
Insert the, hooked end of the cover into the top of the connector.
Figure 24. Attaching the Universal Connector Cover
2.
Press downward on the top of the cover to seat it into the slot.
3.
Press the lower tab of the cover below the connector until it snaps in place.
Top
Top
Slot
Hooked End
Tab
Bottom
Hooked End
Bottom
Slot