Keypad And Keypad/Option Board Disassembly; Figure 33. Remove The Backup Battery; Table 19.Keypad And Keypad/Option Board - Motorola XTS 2500 Basic Service Manual

Keypad and
Keypad/Option
Board Disassembly

Figure 33. Remove the Backup Battery

For this section, please refer to the Model III exploded view and parts list on page 35 for
part numbers and more information on the location of parts in the radio. (For the Model II
keypad, please refer to the exploded view and parts list on page 34.)
Table 19. Keypad and Keypad/Option Board
Exploded
View Item Motorola Part Number
Number
2 0185948D01
3 8485939D01
6 7285726C01
7 7585776C01
9 4285214D01
22 3285270D01
1. The keypad and keypad board can be disassembled without the disassembly of the
display or speaker/microphone flex assembly.
2. If the disassembly of the keypad or the keypad printed circuit board is required, lift
the microphone flex circuit up to move it out of the way.
3. Disconnect the display connector, and move the tail of flex circuit out of the way.
4. To remove the keypad retainer shield, insert the tip of a "penknife size," flat-bladed
screwdriver in the opening at the end of the keypad retainer arm tab. Pry the tab away
from the side of the front cover until it moves past the ledges on the side wall. Repeat
this procedure for the four remaining retainer arm tabs.
Be careful not to mar the O-ring sealing area on the housing. Marring
! !
the front cover O-ring sealing areas will prevent the radio from
sealing properly.
W A R N I N G
Disassembly/Assembly
Description
Keypad Board, Model III
Assembly Speaker/Microphone/Universal
Connector Flex
Display Module
Keypad, Full (for Model III only)
Retainer, Keypad
Seal, Main O-ring
47