Troubleshooting; Status Icons - Motorola APX 3000 User Manual

68012007043-EM
Chapter 4 : Status Indicators
4.2.1

Troubleshooting

Scenarios
LED indicator on the radio
is not functioning during
transmit and receive or any
other operation
No LED feedback after
turning on your radio using
on/off switch
Cannot connect with the
Bluetooth accessory
4.3

Status Icons‡

The 112 x 32 pixel monochrome display screen of your DRSM shows your radio status and operating
conditions.
Icon
or
28
Solutions
The radio might be preprogrammed in lights off mode in the current
channel. For covert operation, the LEDs can be preprogrammed to
turn off with specific zones or channels. Add key words such as
"Lights off" or "Lights on" to the zone or channel Voice Announce-
ments.
NOTE: No LED indication occurs when your radio re-
ceives a clear (non-secured) transmission in Trunking
Mode.
Check your battery by docking it into the charger. If the battery
is good, it might be the reason that the radio was turned off at a
preprogrammed zone/channel which the LED lights are not shown
for covert operation. Change to a zone/channel that LED lights are
enabled. Connect an audio accessory to hear the audio alerts or
transmission.
Check the accessory battery and ensure that the battery is still
good. Also check the accessory device is in the pairing mode.
Description
For IMPRES battery operation only – the icon shown indicates
the charge remaining in the battery.
For all battery operation – the icon blinks when the battery is low.
Direct
On
Radio is configured for direct radio-to-radio communication
(during conventional operation only).
Off
Radio is connected with other radios through a repeater.
Selected channel is being monitored (during conventional opera-
tion only).
When the radio displays L, the radio is set at Low power.
When the radio displays H, the radio is set at High power.
Radio is scanning a scan list.