Keypad And Keypad Option Board Reassembly; Display Reassembly; Speaker, Microphone, And Universal Connector Flex Reassembly; Figure 39. Lock Retainer Catches To Radio Body - Motorola XTS 2500 Basic Service Manual

Keypad and Keypad
Option Board
Reassembly

Display Reassembly

Speaker,
Microphone, and
Universal Connector
Flex Reassembly
1. Insert the keypad into the front cover. Align the keypad to the pins in the front cover.
2. Replace the board on the locator pins.
3. Replace the keypad retainer legs on the PTT side first. Then, press the retainer down
and snap the other two legs into place on the universal connector side; make sure that
all four legs snap into place. If necessary, use a small, flat-bladed screwdriver to put
pressure on the corner bend of each retainer leg.

Figure 39. Lock Retainer Catches to Radio Body

1. Slide the two bottom tabs of the display module, with the LCD facing the front
housing lens, into the grooves located above the keypad assembly area in the front
cover housing. Gently press on the upper portion of the display until it snaps into
place past the two small hooks in the housing.
2. Connect the display flex to the keypad option board connector.
1. Insert the microphone boot into the pocket in the front cover housing.
2. Insert the microphone boot plastic retainer. Make sure the retainer is securely hooked
to the front cover.
3. Center the speaker in the speaker recess. Make certain the speaker is correctly nested
inside the front cover.
4. Before you replace the speaker retainer, be sure the retainer is placed between the
speaker-microphone flex circuit and the speaker. Insert the flat end of the speaker
retainer into the opening in the front cover. Press the other end of the retainer against
the speaker. Hold the retainer in place with your thumb while pushing down on the
retainer with a flat-bladed screwdriver. Use the screwdriver to push down on the
portion of the speaker retainer that is pointing toward the bottom of the radio. Move
the retainer by pushing it toward the bottom of the radio. Slide it into the front cover
slot above the display.
5. Connect the universal flex to the pins and press into place.
Disassembly/Assembly
53