Display Disassembly; Figure 36. Display Disassembly; Table 20.Display Disassembly - Motorola XTS 2500 Basic Service Manual

Display
Disassembly
For this section, please refer to the Model III exploded view and parts list on page 35 for
part numbers and more information on the location of parts in the radio. (For the Model II
display, please refer to the exploded view and parts list on page 34.)
Exploded
View Item Motorola Part Number
Number
1 1585746D03
2 0185948D01
6 7285726C01
9 4285214D01
1. The display assembly can be removed without the disassembly of the keypad board or
the speaker-microphone flex assembly. If the disassembly involves the removal of the
display module, disconnect the display flex from the keypad option board connector.
Take care not to damage the display. Do not cut, bend, or pinch the heat
!
seal. Display modules contain CMOS devices. Be sure to use ESD
protection.
C a u t i o n
2. The display module snaps into the front cover assembly. Insert two flat-bladed
screwdrivers between the flexible beam at the top of the display module (one on each
side). Deflect the beam down until it moves past the hooks on the front cover. The
display module is hooked to the front cover at the base of the display. Lift the top of
the display module past the hooks and remove it from the front cover.
Table 20. Display Disassembly
Cover, Front Assembly Kit (Model III)
Keypad Board, Model III
Display Module
Retainer, Keypad

Figure 36. Display Disassembly

Disassembly/Assembly
Description
49