Transmitter Controls; Power System; Steering Wheel - ECX Revenge E Instruction Manual

en

transMItter controls

reverse switch
BIND ST
N R N
steering trim
Adjust to make the
vehicle drive straight
with no input at the

steering wheel

Power switch
Power on or off
the transmitter
Battery level Indicator
Solid Green:
Battery voltage
is good (Above 4V).
Flashing Green:
Battery voltage is
critically low (below
4V). Replace batteries
rf Mode
The DX2E has a France RF Mode that
complies with French regulations. The DX2E
must be in France mode when used outdoors
in France. At all other times, the transmitter
should be in Standard mode.

PoWer systeM

The Revenge ESC is capable of operating from 7.2 to 14.8V. The
included 550 size 4-pole 2500KV motor is specifically developed
and geared (16T) for use up to 11.1V (3S). However it is highly
recommended to use the optional DYN3739 motor for
14.8V (4S) operation.
6
Allows you to change
the direction of
TH
steering (ST. REV)
and throttle (TH. REV)
R
controls. (Default
settings are "R"
for steering and
"N" for throttle)
throttle trim
Adjusts the
neutral point
of the electronic
speed control
ST. TRIM
TH. TRIM
france mode
Turn the wheel full left, pull the trigger full
throttle and hold down the bind button while
turning on the transmitter. The Green LED
will flash twice.
BIND ST TH
N R N R
ST. TRIM
ST. RATE
TH. TRIM
ST. RATE
ST. TRIM
throttle trigger
TH. TRIM
Forward
steering rate
Adjusts the amount the
rudder moves when the
steering wheel is turned
left or right
steering Wheel
Controls steering.
Right and Left
steering with ST.
REV Switch on
R (See ST. REV
switch)
ST. RATE
Controls power
to the engine
for forward or
reverse (See TH.
REV switch)
Reverse
Stop
standard mode
(default preset set at factory)
Turn the wheel full right, pull the trigger
full throttle and hold down the bind button
while turning on the transmitter. The Green
LED will flash once.