Page 1
4WD Monster Truck. Dieses 1:18 Scale Model öffnet Ihnen die Welt des RC Car Sports. MANUALE Nous vous félicitons pour l’achat du ECX Ruckus 4WD Monster Truck. Ce modèle 1:18 vous introduit au sport de la conduite RC. Congratulazioni per l’acquisto di questo Ruckus ECX 4WD Monster Truck.
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language: The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND little or no possibility of injury.
WATER-RESISTANT VEHICLE WITH WATERPROOF ELECTRONICS Your new Horizon Hobby vehicle has been designed and built with • Driving in wet conditions can reduce the life of the motor. a combination of waterproof and water-resistant components to al- The additional resistance of operating in water causes excess strain.
COMPONENTS 1. ECX ® Ruckus ® 1:18-scale 4WD Monster Truck 2. Transmitter 3. AA Batteries (4) 4. 7.2V 900mAh Ni-MH Battery 5. 100mAh Wall Charger CHARGING WARNINGS • Always connect to the charger correctly. WARNING: Failure to exercise caution while using this product and comply with the following warnings could •...
REMOVING THE VEHICLE BODY INSTALLING TRANSMITTER BATTERIES 1. Slide the panel open on the bottom of the transmitter. 2. Obey the battery plus (+) and minus (-) diagram in the transmitter to install 4 AA batteries. 3. Slide the panel closed. We recommend using only alkaline AA batteries in the transmitter, however, it is possible to use rechargeable Ni-MH batteries.
TRANSMITTER CONTROLS Reverse Switch Battery Level Indicator Solid Red and Green: Battery voltage is good (above 4V). Solid Red: Battery Allows you to change the direction of voltage is critically low steering (ST) and throttle (TH) controls. (below 4V). Replace (The default setting for steering and transmitter batteries.
GETTING STARTED 1. Power on the transmitter. 2. Connect the battery to the Electronic Speed Control (ESC) / Receiver unit and power on the vehicle. 3. Do a test of the transmitter’s control of the vehicle with 4. Start driving slowly. If the wheels are not straight, adjust the the vehicle’s wheels off the ground.
OPERATION • ALWAYS turn on your transmitter before you turn on the receiver in the vehicle. Always turn off the receiver before turning your transmitter off. • ALWAYS operate your vehicle in a wide open area. Operating the vehicle in a small space or indoors can cause overheating at low speeds.
SETTING THE GEAR MESH The gear mesh has already been set at the factory. Setting the gear mesh is only necessary when changing motors or gears. You must remove the vehicle’s gear cover (A) to make this adjustment. Proper gear mesh (how the gear teeth meet) is important to the performance of the vehicle.
MAINTENANCE Your ECX 1:18 Ruckus 4WD Monster Truck needs periodic mainte- 4. If you plan to store your vehicle for more than a week, it is a nance and cleaning to keep performing at its optimal level. good idea to remove the batteries from the radio and vehicle...
LIMITED WARRANTY What this Warranty Covers questions and service you in the event that you may need any Horizon Hobby, Inc., (Horizon) warrants to the original purchaser assistance. For questions or assistance, please visit our website that the product purchased (the “Product”) will be free from at www.horizonhobby.com, submit a Product Support Inquiry, or defects in materials and workmanship at the date of purchase.
Declaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2013062305 Product(s): ECX Ruckus 1:18th 4WD MT RTR Item Number(s): ECX01000EU, ECX01000UK Equipment class: The object of declaration described above is in conformity with the requirements of the specifi cations listed below, following the provisions of the European R&TTE Directive 1999/5/EC, EMC Directive 2004/108/EC and LVD Directive 2006/95/EC:...
ECX 1:18 Antriebsachsen Set de cardans Set completo trasmissione: 11 ECX212003 1:18 4WD All 1:18 4WD tutti Wheel Hex Set: 1:18 4WD All ECX 1:18 Mitnehmer Set Set d’hexagones de Set esagoni ruote: 1:18 4WD 12 ECX212004 roues tutti Hingepin Set: 1:18 4WD All ECX 1:18 Hingepin Set Set d’axes de suspension Set perni cerniere: 1:18 4WD...