Skyvue SKY5230 Owner's Manual page 52

Using the Internet
Checking Your Internet Connection
• If " " or " " is displayed after you connect to the
Internet, check your TV's network settings and connection.
• When the AQUOS ADVANTAGE LIVE screen appears, now
you are connected to the Internet.
• You can also display the AQUOS ADVANTAGE LIVE screen
by pressing FAV APP on the remote control unit.
• If you have failed to connect to the Internet in the above
operation, then an error message will appear. In this case,
press EXIT to exit from the connected TV feature to make
changes to the network settings.
• If you still cannot connect to the Internet, please consult
your Internet service provider or telephone company.
• When an application is used, you cannot make settings for
"Internet Setup".
If you need to make the settings of "Internet Setup", press
EXIT to exit from the connected TV feature.
If you cannot connect to the Internet
Perform the procedures below to check your TV's
network settings.
IP Setup
1
Press EXIT to exit from the connected TV feature.
2
Press MENU to display the MENU screen, and then
press c / d to select "Initial Setup".
3
Press a / b to select "Internet Setup", and then
press ENTER.
4
Press a / b to select "Network Setup", and then
press ENTER.
5
Press a / b to select "IP Setup", and then press
ENTER.
• Check that numbers are displayed for each setting.
• If there are any settings without numbers, specify the
numbers by following the on-screen instructions.
IP Address
Netmask
Gateway
DNS
MAC Address : XX:XX:XX:XX:XX:XX
Change
6
Press MENU to exit.
2012 SKYVUE
LC-80LE633U_70_60_52LE640U_C6400U_E.indb 59
Example
Setting IP information
[Current Setup]
: Auto Setup
: Auto Setup
: Auto Setup
: Auto Setup
Initialize
AQUOS Advantage Live
This function can be used to display up-to-date
information and allow you to receive support service
over the network.
• When you are not connected to the Internet, a network
function explanation screen is displayed.
The services displayed vary depending on
circumstances.
Press a / b / c / d to select the desired service.
PressEXIT to exit from the connected TV feature.
• The display may change as a result of a software update.
• When displaying TV+Web with a channel in which the
V-Chip is enabled, the cursor keys on the remote control
unit do not function.
52
2012/01/05 16:20:37