Skyvue SKY5230 Owner's Manual page 37

On-Screen Display Menu
■ Updating the Software via the Network
1
Press a / b on the Manual Update screen to select
"Network Update", and then press ENTER.
• The TV connects to the network and checks for updates.
• To cancel, press ENTER.
Checking for the latest software version..
2
The current version of the TV and the latest version
of software are displayed. To update the TV
software, select "Yes", and then press ENTER.
Latest software version has been found.
Current Version
XXXXXXXX
Latest Version
XXXXXXXX
Estimated Update Time
XX
Update time may change depending on the network environment
Yes
• When a server connection cannot be established or an
update is not available, a message is displayed.
If a server connection cannot be established, check the
broadband connection and Internet Setup.
Check the network settings and try again.
The TV does not need to be updated.
3
After the update fi le is downloaded, the software
update process begins.
Downloading the latest software..
Update Version
XXXXXXXX
Updating to the latest software..
Update Version
XXXXXXXX
Remote control operation is disabled during update process.
2012 SKYVUE
LC-80LE633U_70_60_52LE640U_C6400U_E.indb 38
Connecting to Internet..
Accessing..
Abort
A software update is available.
Proceed with update?
No
Cannot reach the server.
OK
OK
30%
Abort
50%
Do not unplug AC cord.
CAUTION
• Do not unplug the AC cord while the software is
being updated.
4
When the software is successfully updated, a
screen is displayed indicating that the update
process is completed.
A screen indicating that the update is completed
is displayed. 4 seconds later, the TV restarts
automatically.
Software update is complete.
Update Version
XXXXXXXX
• If the software was not updated successfully, check the
broadband connection and Internet Setup, and then try
updating the software again.
Failed to complete update.
Please retry from Software Update menu.
■ Updating the Software with a USB Memory Device
CAUTION
• Do not remove the USB memory device or unplug
the AC cord while the software is being updated.
• Be sure to properly follow the whole procedure
described below, step by step. Otherwise, for
example, the TV cannot read the data in the USB
memory device and software updating will fail.
1
Insert the USB memory device with the update fi le
into the USB 1 or USB 2 terminal on the TV.
• When you update the software, use only one USB
terminal. Either USB 1 or USB 2 is usable.
2
Press a / b on the Manual Update screen to select
"USB Update", and then press ENTER.
OK
or
37
2012/01/05 16:20:33