Airflow Direction Control - Midea INVERTER SPLIT TYPE ROOM AIR CONDITIONER User Manual

Airflow direction control

Range
Range
Lever
OPERATING INSTRUCTIONS
Adjust the air flow direction properly otherwise, it
might cause discomfort or cause uneven room
temperatures.
Adjust the horizontal/vertical louver using the remote
controller.
Adjust the vertical louver manually only(For some models).
To set the horizontal/vertical air flow direction
(automatically)
Perform this function while the unit is in operation.
Use the remote controller to adjust the air flow
direction. The horizontal/vertical louver can be moved
O
at an angle of 6 for each press or set to move up
and down(horizontal louver) or left and right(vertical louver)
automatically. Please refer to the REMOTE CONTROLLER
,,
ILLUSTRATION for details.
To set the horizontal air flow direction (left - right)
(manually)(for some models)
Adjust the vertical louver manually using the lever
on the left or right side of the vertical louver arm
(Depending on model). Take care not to catch
fingers on the fan, horizontal louver or to damage
vertical louvers. When the air conditioner is in
operational and the horizontal louver is in a specific
position, move the lever at left (or right, depending
on model) end of the air outlet to the desired position.
!
CAUTION
Do not operate the air conditioner for long periods
flow direction set downward in cooling or dry mode. Otherwise,
condensation may occur on the surface of the horizontal louver
causing moisture to drop on to the floor or on furnishings.
Do not move the horizontal louver manually. Always use the
SWING or AIR DIRECTION button. If you move this louver
manually, it may malfunction during operation. If the louver
malfunctions, stop the air conditioner once and restart it.
When the air conditioner is started immediately after it was
stopped, the horizontal louver might not move for approximately
10 seconds.
Open angle of the horizontal louver should not be set too small,
as COOLING or HEATING performance may be impaired due
to too restricted air flow area.
Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power),
the horizontal louver may generate a sound for 10 seconds,
this is a normal operation.
8
, ,
with the air