Midea INVERTER SPLIT TYPE ROOM AIR CONDITIONER User Manual page 7

B) It displays the room temperature when the air conditioner is in FAN only operation.
C) Displays the malfunction code or protection code.
D) When SELF CLEAN feature is activated, it displays
OPERATION FREQUENCY display:
This display is separated into five zones. The zones illuminate based on the compressor current
frequency. For example, higher frequency will illuminate more zones.
Special functions
Clean Air function(optional)
Air quality is the key to comfort, this air conditioner is equipped with Ionizer device. Ionizer can
generate abundant anions to fill the room with refreshing and nature air. Your whole family will
enjoy a natural, pure and healthy air everyday.
Auto Clean function(optional)
Function used after the Shut Down of cooling operation to clean the Evaporator and keep it as
fresh for the next operation. This function is easy to be operated as it is accessed through the
Remote Controller.
For cooling only models, the air conditioner will operate under FAN ONLY mode at LOW fan
speed for 16 minutes, and then stop the operation and the unit turn off.
For cooling & heating models, the air conditioner will operate : FAN ONLY mode at Low fan
speed(13 minutes)--Heating operation with LOW fan speed (1 minute)---FAN ONLY
operation(2 minutes)--Stop Operation---Turn off the unit.
Note:
This function is only available under COOL(AUTO COOL, FORCED COOL) and DRY mode.
Before select the function, it is recommended to run the air conditioner under Cooling
operation for about half an hour.
Once the Auto Clean function is activated, all TIMER setting will be cancelled.
During Auto Cleaning operation, Press the AUTO CLEAN button again will stop the operation
and turn off the unit.
Follow Me function(optional)
The remote control serves as a remote thermostat allowing for the precise
temperature control at its location.
To activate the Follow Me feature, point the remote control towards the unit and press the Follow
Me button. T he remote display is actual temperature at its location. The remote control will send
this signal to the air conditioner every 3 minutes interval until press the Follow Me button again.
If the unit does not receive the Follow Me signal during any 7 minute interval, the Follow Me
mode will be cancelled automatically.
OPERATING INSTRUCTIONS
, ,
,,
.
6