Airflow Direction Control - Midea Elite Plus MSE18HRN1 User Manual

OPERATING INSTRUCTIONS

Airflow direction control

SET TEMPERATURE( C)
AUTO
COOL
DRY
HEAT
TEMP
ON/OFF
MODE
SWING
ECONOMY
ION
RESET LOCK
FOLLOW
ME
Range
Range
Adjust the air flow direction properly otherwise, it might
cause discomfort or cause uneven room temperatures.
Adjust the horizontal louver using the remote controller.
Adjust the vertical louver manually.
FAN
HIGH
MED
To set the vertical air flow(Up--Down) direction
LOW
Perform this function while the unit is in operation.
Keep pressing the SWING button on the remote
controller to move the louver to the desired direction.
Press SWING button to lock louver in desired position.
FAN SPEED
To set the horizontal air flow direction (left - right)
TIMER ON
Adjust the vertical louver manually using the lever on the
TIMER OFF
left or right side of the vertical louver arm (Depending on
model). Take care not to catch fingers on the fan, horizontal
LED
TURBO
DISPLAY
louver or to damage vertical louvers. When the air
conditioner is in operation and the horizontal louver is in
a specific position, move the lever at left (or right, depending
on model) end of the air outlet to the desired position.
To automatically swing the air flow direction (up - down)
Perform this function while the air conditioner is in operation.
Keeppressing the SWING button without releasing for more
than 2 seconds, the horizontal louver will swing up and down
automatically.
To stop the function, press the SWING button again.
CAUTION
!
The SWING button will be disabled when the air conditioner is not in
operation(including when the TIMER ON is set).
Do not operate the air conditioner for long periods with the air flow
direction set downward in cooling or dry mode. Otherwise,
condensation may occur on the surface of the horizontal
louver causing moisture to drop on to the floor or on furnishings.
Do not move the horizontal louver manually. Always use the SWING
button. If you move this louver manually, it may malfunction during
operation. If the louver malfunctions, stop the air conditioner once and
restart it.
When the air conditioner is started immediately after it was stopped,
the horizontal louver might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as
COOLING or HEATING performance may be impaired due to too
restricted air flow area.
Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power), the
horizontal louver may generate a sound for 10 seconds, this is a
normal operation.
8