Sv4.T Overview - SpaNet SV2 User Manual

SV4.T Keypad Overview
Buttons and indicator LEDs
AUTOMATIC INDICATOR LED
This LED will turn on whenever the
filtration pump is in automatic mode.
HEATER INDICATOR LED
This LED will turn on when the
heater or heat pump (if fitted)
is operating.
SANITISER INDICATOR LED
This LED will turn on to indicate
that the ozone or uv sanitiser unit
is operating (if fitted).
SLEEP TIMER
INDICATOR LED
This LED will turn on
PUMP (A,B,C,D)
when the controller is
BUTTONS
in a sleep mode.
Used to toggle the filtration pump and / or
any additional jet pump(s) on / off (if fitted).
SV Series Spa Controls
A B C D
BLOWER BUTTON
Press to toggle blower
on/off. A single press
turns blower on in
vari-speed mode. Use
up & down buttons to
vary speed. A double
press activates the
ramping mode.
7
UP BUTTON
Short single presses toggle through the three
display modes: W.TMP = Water Temperature,
S.TMP = Set Temperature, TIME = Clock.
Holding the button will force the controller to
begin adjusting the set temperature and will raise
the set temperature point.
Also used for adjusting settings.
LIGHT (ON / OFF) BUTTON
Press to toggle spa lights on / off.
LIGHT (SPEED / COLOUR) BUTTON
Press to activate light speed or user colour
selection menus. Use up & down buttons to
adjust.
OK BUTTON
Used to confirm and save setting adjustments
or to enter setting adjustment menus.
INVERT SCREEN BUTTON
Press to flip screen 180
when spa in use.
DOWN BUTTON
Short single presses toggle through the three display
SANITISE BUTTON
modes: W.TMP = Water Temperature, S.TMP = Set
Press once to
Temperature, TIME = Clock.
activate a 20 minute
Holding the button will force the controller to begin
sanitisation and
adjusting the set temperature and will lower the set
clean up cycle to
temperature point.
refresh water quality
after spa use. A Also used for adjusting settings.
second press will
cancel the cycle if
already running.
o
for easy viewing