Sv2.T Overview - SpaNet SV2 User Manual

SV2.T Keypad Overview
Buttons and indicator LEDs
AUTOMATIC INDICATOR LED
This LED will turn on whenever the
filtration pump is in automatic mode.
HEATER INDICATOR LED
This LED will turn on when the
heater or heat pump (if fitted)
is operating.
SANITISER INDICATOR LED
This LED will turn on to indicate
that the ozone or uv sanitiser unit
is operating (if fitted).
SLEEP TIMER
INDICATOR LED
This LED will turn on
PUMP A BUTTON
when the controller is
in a sleep mode.
Used to toggle the
filtration pump
on / off / auto
SV Series Spa Controls
PUMP B BUTTON BLOWER BUTTON
Used to toggle any Press to toggle blower
additional jet pump on/off. A single press
on / off (if fitted). turns blower on in
vari-speed mode. Use
up & down buttons to
vary speed. A double
press activates the
ramping mode.
LIGHT BUTTON
Press to toggle spa
lights on / off. When
light is first turned
on the user has the
ability to adjust the
light effect mode or
colour via the up,
down & OK buttons.
5
UP BUTTON
Short single presses toggle through the three
display modes: W.TMP = Water Temperature,
S.TMP = Set Temperature, TIME = Clock.
Holding the button will force the controller to
begin adjusting the set temperature and will raise
the set temperature point.
Also used for adjusting settings.
SANITISE BUTTON
Press once to activate a 20 minute sanitisation
and clean up cycle to refresh water quality after
spa use. A second press will cancel the cycle if
already running.
OK BUTTON
Used to confirm and save setting adjustments
or to enter setting adjustment menus.
WATER TEMP / TIME BUTTON
A shortcut key designed to quickly toggle
between actual water temp and time display
modes.
DOWN BUTTON
Short single presses toggle through the three display
modes: W.TMP = Water Temperature, S.TMP = Set
Temperature, TIME = Clock.
Holding the button will force the controller to begin
adjusting the set temperature and will lower the set
temperature point.
Also used for adjusting settings.