SpaNet SV2 Quick Reference Manual

AUTOMATIC INDICATOR LED
This LED will turn on whenever
the filtration pump is in automatic
mode.

HEATER INDICATOR LED

This LED will turn on when the
heater or heat pump (if fitted)
is operating.

SANITISER INDICATOR LED

This LED will turn on to indicate
that the ozone or uv sanitiser
unit is operating (if fitted).
SLEEP TIMER
INDICATOR LED
This LED will turn on
when the controller is

PUMP A BUTTON

in a sleep mode.
Used to toggle the
filtration pump
on / off / auto.
POWER

DISPLAY MODE ICONS

Water Temperature
Set Temperature
Clock

STATUS ICONS

Keypad locked
Sanitise cycle operating
40.00
OFF OFF
ON ON
0 / UV
3
SAT SUN MON TUE WED THU FRI

PUMP B BUTTON

BLOWER BUTTON

Used to toggle any Press to toggle blower
additional jet pump on/off. A single press
on / off (if fitted). turns blower on in
vari-speed mode. Use
up & down buttons to
vary speed. A double
SMART
press activates the
ramping mode.
MENU ICONS
Sleep timer menu icon
Light menu icon
Blower menu icon
Filtration cycle operating
Fault condition has occured
°C AM
°F PM
MODE
SPD
BRT
SV-2T

LIGHT BUTTON

Press to toggle spa
lights on / off. When
light is first turned
on the user has the
ability to adjust the
light effect mode or
colour via the up,
down & OK buttons.
QUICK REFERENCE GUIDE

UP BUTTON

Short single presses toggle through
the three display modes: W.TMP =
Water Temperature, S.TMP = Set
Temperature, TIME = Clock.
Holding the button will force the
controller to begin adjusting the set
temperature and will raise the set
temperature point.
Also used for adjusting settings.

SANITISE BUTTON

Press once to activate a 20 minute
sanitisation and clean up cycle to
refresh water quality after spa use.
A second press will cancel the cycle
if already running.

OK BUTTON

Used to confirm and save setting
adjustments or to enter setting
adjustment menus.

WATER TEMP / TIME BUTTON

A shortcut key designed to quickly
toggle between actual water temp
and time display modes.
DOWN BUTTON
Short single presses toggle through the three
display modes: W.TMP = Water Temperature,
S.TMP = Set Temperature, TIME = Clock.
Holding the button will force the controller to
begin adjusting the set temperature and will
lower the set temperature point.
Also used for adjusting settings.