Thermostatic Control Operation - Cumberland Stove Works MF3800 Operation And Maintenance Manual

tHerMOStatic cOntrOL OperatiOn

The stove has been designed to run thermostatically in two
different ways. There is a built-in thermostat in the controller,
or a remote thermostat can be installed. At anytime during
normal operation you may turn on or off the thermostatic
control by pressing the ThERMOSTAT ON/OFF button See a
dealer for additional information.
LOcaL t-Stat – The local thermostat is the thermostat
located inside the controller display. To use this mode press
the thermostat button until the following screen is displayed:
LOCAL TSTAT
The L.E.D. light located in the top right corner of the t-stat
button will illuminate. During normal local thermostat
operation, the screen will display (for example) the following:
STPT 72 TEMP 65
RANgE 3 LEVEL 4
During local thermostat operation the TEMP UP and TEMP
DOWN buttons control the thermostat setpoint.
reMOte t-Stat – Remote T-STAT mode is chosen by pressing
the T-STAT button until the following screen is displayed:
REMOTE TSTAT
During this thermostat mode the stove is controlled by a
thermostat that is placed far from the stove. If the stove is in
this mode the screen will display (for example) the following:
REMOTE* TEMP 72
RANgE 3 LEVEL 4
NOTE: The asterisk indicates that the thermostat is calling
for heat.
neVer SHUt dOWn YOUr StOVe BY LeaVinG tHe HOpper
dOOr Open and Unattended. tHiS cOULd create an
UnSaFe cOnditiOn iF tHe dWeLLinG iS Under neGatiVe
preSSUre.
cUMBerLand StOVe WOrkS dOeS nOt recOMMend
BUrninG tHe StOVe On tHerMOStat MOde, eitHer
LOcaL Or reMOte, WHen BUrninG cOrn Or peLLet
BLendS. Spent aSH MateriaL WiLL BUiLd Up in tHe pOt,
inHiBit tHe iGnitOr FUnctiOn and caUSe a ViOLent
iGnitiOn.
To turn off the thermostat mode, press the thermostat
b u t t o n u n t i l t h e fo l l o w i n g s c re e n i s d i s p l aye d :
This will return the stove to manual operation where the heat
level is controlled by using the TEMP UP and TEMP DOWN
buttons.
Once in thermostat mode, the stove will continue to burn on
the chosen range, automatically adjusting to higher levels
until the chosen heat setting is reached. Once the desired
heat setting is reached, the stove will automatically adjust to
lower levels.
If the room temperature is still above the chosen heat setting
after burning on level 1, the stove will automatically shut down
and the screen will display (for example) the following:
cumberlandStoveWorks.com
OPERATIOn AND MAINTENANCE MANUAL
WarninG
caUtiOn
TSTAT OFF
TSTAT STDBY
STPT 72 TEMP 75
Model MF3800
page 15