Trane UHMB060ACV3VA Installer's Manual page 13

Upflow/ horizontal and downflow/ horizontal, gas-fired, direct vent, variable speed inducer, modulating condensing communicating furnaces
Hide thumbs Also See for UHMB060ACV3VA:
Table of Contents

Advertisement

i
BLOWER
DECK
Furnace
Cabinet
Side
Filter Rack
Retaining
Screw/Pin
o
p
Optional door kit
BAYFLTR206
Typical Horizontal Filter Installation
Table 4A
CONVERSION KITS FOR
HORIZONTAL FILTERS
MODEL NUMBERS
*UHMB060ACV3VA
*UHMB080ACV3VA
*UHMC100ACV4VA
*UHMD120ACV5VA
1. *First letter may be "A" or "T"
2. Kit includes Filters and Brackets necessary for Horizontal Filters.
3. Optional Door Kit BAYFLTR206 is also available.
18-CD30D1-9
Furnace
Engagement Hole
For
Filter Rack
Blower
Installation With
Deck
Side
Return
Filter
Rack
Assembly
Airf low
CHAMFER
END OF
FILTER GOES
INTO FILTER
RACK FIRST
CABINET
CONVERSION
WIDTH
KIT NUMBER
17-1/2"
BAYFLTR203
21"
BAYFLTR204
24-1/2"
BAYFLTR205
Installer's Guide
RETURN AIR FILTERS FOR UPFLOW FURNACE IN
HORIZONTAL CONFIGURATION
When the upflow furnace is installed in the horizontal
configuration, the return air filters must be installed
exterior to the furnace cabinet. Remote filter grilles
may be used for homeowner convenience or the filters
may be installed in the duct work upstream of the fur-
nace. See Figure 20. Conversion kits for horizontal fil-
ter installation are shown in Table 4A.
Conversion kits for horizontal filters are BAYFLTR203
for 17 1/2" width cabinets, BAYFLTR204 for 21" width
cabinets, and BAYFLTR205 for 24" width cabinets.
These include filters and brackets necessary for hori-
zontal filters. In addition, optional door kit
BAYFLTR206 is also available. See Figures 20 and 22.
UPFLOW FILTER CLIP/ BRACKET INSTALLATION
1. Determine the location to be used. The furnace
cabinet has dimples for location of the alternate
furnace clips (Side return only). Pre-drill clearance
holes with a 3/16" drill. Bottom return holes are
pre-drilled. Attach clip to bottom channel and rear
of unit with screws provided for bottom return.
2. Install the clips in front and rear of the desired
location using the screws provided. The filter clip
with the leaf spring mounts in the rear of the
cabinet. See Figure 21.
a
ALTERNATE SIDE
FILTER CLIPS
LOCATIONS
ALTERNATE BOTTOM
FILTER CLIPS LOCATIONS
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents