Texas Instruments TI-89 Titanium User Manual page 598

When you select a loop, the loop command
and its corresponding
inserted at the cursor location.
You can then begin entering the commands that will be executed in the loop.
A loop command marks the start of the loop. The corresponding
Note:
marks the end of the loop.
For...EndFor Loops
A
For...EndFor loop
The syntax of the
The ending value can be less than the beginning value, but the increment must be
Note:
negative.
,
For(variable begin
Ê Ë
Ê
variable used as a counter
Ë
counter value used the first time For is executed
Ì
exits the loop when variable exceeds this value
Í
added to the counter each subsequent time For is executed
Programming
command are
End
uses a counter to control the number of times the loop is repeated.
command is:
For
, [, ]
end increment )
Ì Í
:For | Ê
:EndFor
Ê
If the loop requires
arguments, the cursor
is positioned after the
command.
command
End
595