THOMSON ST605 Installation And Setup Manual page 38

LED status
WLAN LED is flashing or
not lit
Red Internet LED or No
Internet LED
You can find a comprehensive LED overview in the User's Guide.
32
Possible solutions
>
The WLAN LED flashes if there is wireless LAN activity and can have
different colours:
Green: The Thomson Gateway wireless access point is operating in
the highest security mode (WPA). Make sure to use the same WPA
encryption on the WLAN client.
Amber: The Thomson Gateway wireless access point is operating in
medium security mode (WEP). Make sure to use the same WEP
encryption on the WLAN client.
Red: The Thomson Gateway wireless access point uses no security.
>
The WLAN LED is not lit if the Thomson Gateway wireless access point is
disabled. For wireless networking, make sure the WLAN is enabled on the
Thomson Gateway. Proceed as follows:
1 Go to the Thomson Gateway Web pages.
2 In the menu select Office Network > Interfaces.
3 Click WLAN.
4 Click Configure.
5 Select Interface Enabled.
- OR -
1 Press and hold the Association / Registration button until the WLAN
LED is lit (green, amber or red).
2 The WLAN LED is toggling between red and green: If new stations are
only allowed via registration and if you pressed the Association /
Registration button, the ACL will be unlocked for 30 seconds during
which you can connect new wireless clients.
>
There was an authentication failure. This will usually present itself as an
error message regarding an incorrect password.
Check whether your user name is correct. For ADSL connections, the
user name is normally in the form of username@ISP.
Check whether your password is correctly entered. The password is
case sensitive.
If you continue to get password failures, contact your ISP.
>
The wrong service profile was selected. Restart the setup of your
Thomson Gateway, and make sure to select the correct service profile.
Chapter 4
Troubleshooting
E-DOC-CTC-20060911-0089 v1.0