THOMSON ST605 Installation And Setup Manual page 17

Chapter 2
Basic Installation
3 Make one of the following connections:
Connect the yellow RJ-45 Ethernet cable to the yellow (indicated) Ethernet port on your Thomson
Gateway and the other end to the computer's Ethernet port.
For wireless networking (only possible on a 608 WL/620), plug a wireless card or adapter into your
computer.
i
4 Once the hardware is installed and connected to the Thomson Gateway, the procedure continues with
configuring your Internet connection.
i
If the wizard does not detect a connection, an error message will be displayed. Refer to
wizard does not detect a connection" on page
Proceed with
E-DOC-CTC-20060911-0089 v1.0
In case of problems or for advanced information, see
" Configuring the Internet connection" on page
"2.5.1 Wireless Setup" on page
35.
12.
23.
" The
11