THOMSON ST605 Installation And Setup Manual page 23

Chapter 2
Basic Installation
Starting the Easy Setup wizard
You can also start the Easy Setup wizard from within the embedded Web pages. Proceed as follows:
1 Browse to the Thomson Gateway pages on
default).
2 In the menu, click SpeedTouch.
3 In the Pick a task list, click Set Up.
Using Easy Setup
In the Easy Setup wizard:
1 Click Next to proceed. If for some reason you want to abort the wizard, click Cancel.
2 Choose the Service provided by your ISP (IPoA for instance) and click Next.
3 Select the appropriate VPI/VCI - and, if required, the Connection Type - provided by your ISP, and then
click Next.
4 For a PPP connection, fill in the Internet Account settings (PPP user name and password or - in case you
use IPoA - the Local and Remote IP address) provided by your ISP, and then click Next.
5 Fill in a Security user name and Password for your Thomson Gateway.
i
The factory default user is 'Administrator' and its password is blank. It is advisable to specify
another Administrator user name and password to protect your Thomson Gateway from
security violation, as described in
6 In the next window you can review your settings, before starting the configuration of your Thomson
Gateway. If something is missing or incorrect, click Back. To confirm your settings, click Start.
7 Wait until the configuration is finished, and then click Finish.
E-DOC-CTC-20060911-0089 v1.0
http://dsldevice.lan or on its IP address,
"2.6 Basic Security" on page
192.168.1.254 by
25.
17