Programming The Wake Time And Method - Silvercrest SRD 250 A2 Operating Instructions Manual

Handling and operation
NOTE
► The technical realities of the appliance permit an adjustable
frequency range outside the permitted frequency ranges
of VHF (FM) 87.5 - 108 MHz and/or MW (AM) 526,5 -
1606,5 kHz. In some countries, diff erent national regulations
may apply to the assigned radio frequency ranges. Please
note that information received outside of the assigned radio
frequency ranges may not be used, passed on to third parties
or otherwise misused.

Programming the wake time and method

When programming the alarm times, you can select whether,
at the programmed time, alarm tones should sound or the radio
should start playing. Two diff erent alarm times (Alarm 1/Alarm 2)
can be programmed.
♦ Press and hold the AL1 button
the hour indicator blinks.
♦ Press or hold down the UP button
to set the hour.
♦ Press the AL1 button
the minute indicator blinks.
♦ Press or hold down the UP button
to set the minutes.
♦ Press the AL1 button
time is accepted and in the display
indicator.
♦ Press the UP button
Alarm tone or
SRD 250 A2
or AL2 button
16
12
or AL2 button
16
12
or AL2 button
16
2
to set the desired wake method (
12
= Radio).
. In the display
15
or DOWN button
again. In the display
15
or DOWN button
again. The set wake
15
appears the wake method
GB
CY
2
10
2
10
=
13