Cleaning
Wipe off dirt on the purifi er case using a soft cloth that is moistened
with water and fully wrung. For heavy dirt, use a soft cloth moistened
with neutral detergent thinned with water. After removing dirt, use a dry
soft cloth to wipe off moisture so that no detergent will remain.
To clean the remote infrared receiver, use a thin cotton swab slightly
moistened with water to wipe off dirt. After that, use a dry cotton swab
to remove the moisture.
Remove dust on the surfaces of the panel, air inlet, odor sensor, dust
sensor section and humidity sensor using a vacuum cleaner attachment
for cleaning shelves. Then wipe off with a soft cloth.
Vacuum cleaner attachment
for cleaning shelves
Carry out the periodical cleaning every 3-6 months.
Otherwise poor performance of the dust sensor will result.
Remove the dust sensor cover.
Do not wipe the lens forcibly. It may cause damage.
Do not disengage and engage the tabs of the dust sensor cover forcibly.
CAUTION
It may cause damage.
E-22
(Continued)
Purifier Body
Panel
Dust sensor
(Cleaning guide: every 3-6 months)
(Guide for cleaning: Once a month)
Dust sensor section
Humidity sensor
Remote infrared receiver
Wipe the lens with a cotton swab.
Soak a cotton swab with a little water
and wipe off any heavy dirt with it.
After cleaning the dust sensor,
reinstall the dust sensor cover.
Odor sensor
Lens
Remote infrared
receiver