Cleaning; Purifi Er Body; Pre-Fi Lter - Hitachi EP-A3000 Instruction Manual

Cleaning

Do not splash water on the purifier body. Water splash can be a cause of failure.
Note
Do not use a volatile solvent, such as gasoline, thinner, benzene, wax, kerosene, alcohol, etc. or
polishing powder, or alkaline cleaner.
Such chemicals could cause deformation, discoloration, damage or removal of prints.
When using a chemically treated cloth, follow its instructions.
Never use dryer or heater to dry the purifier case. Heating could cause deformation.
Note Lay a soft cloth or the like beneath the purifier to protect the floor against scratch.
Remove dirt on the unit or panel with a soft cloth moistened with water or neutral detergent,
and wrung. After removing dirt, wipe the unit or panel carefully so that there is no detergent
on it.
To clean the pre-filter, follow the steps below.
Remove the panel.
Lay the air purifier unit with the
front upward on a stable and
horizontal surface.
Put your fingers under the
panel (two locations), lift
the panel slowly and slide
it slightly to the top side to
remove.
Note Do not open the panel forcibly. Parts may break.
Clean the pre-filter.
Use a vacuum cleaner or the like to remove dust. If the dust cannot be removed, wash
it off with water. After washing, fully drain the prefilter and then dry it in well-ventilated
place where not exposed to sunlight.
When you wash the prefilter, use a soft brush such as an old toothbrush.
If you want to remove dust from the filter, use a vacuum cleaner or the like.
Reattach the pre-filter.
Insert the prefilter securely into the holes on the unit in the reverse order of step
lock it in place.
Install the filter so that the marking "
Reattach the panel.
Insert the two tabs on the inside of the panel upper side securely into
the two cylindrical notches on the top of the unit.
Insert one tab into a cylindrical notch and then do the other tab
in the same manner.
Gently push bottom of the panel until it clicks to close it
securely.
The pre-filter is a consumable part.
When damaged pre-filter needs to be replaced, purchase the replacement part (Part No. EP-BX40-002).
E-12
EP-A3000.indd 12
(Guide for cleaning: Once a month)
Purifier Body
Pre-filter
Remove the pre-filter.
Hold the lugs to remove the prefilter.
Lugs
Holes
" on the filter side face will face the panel.
Holes
and
Tabs
Cylindrical
notches
11/18/2011 8:40:41 AM