Printing Out Information; Interfacing With A Computer - Setra Systems Quick Count Operator's Manual

PRINTING OUT INFORMATION

Your Setra Quick Count scale is designed to print out requested or
stored information regarding a given batch when connected to an optional
serial printer (see Appendix I). To print out information using the
Setra Model 240P
procedure:
1. Connect the printer's AC adaptor to a 110-volt outlet.
2. Connect the other end of the adaptor to the printer.
3. Connect the appropriate end of the printer connection cord to the
printer.
4. Connect the other end of the connection cord to the scale's RS-232
port.
5. Perform the necessary counting or weighing procedures on the scale.
6. Make sure the printer is turned on (as indicated by the printer's
green light). If the printer is not on, press the black button on
the side of the printer.
7. Press the print key on the scale.
8. Repeat Steps
information.
NOTE: a. When using a printer other than the Setra 240P or 340P, set the
baud rate and parity of your scale to match the printer (see
Appendix I).
b. It is possible to customize the information to be printed to
either a dot matrix printer or thermal printer for bar codes
with ScriptCoder
for more information.

INTERFACING WITH A COMPUTER

Your Setra Quick Count scale is designed to interface with a wide
variety of computers. For information on how to connect your scale to a
computer and transmit data ask your local authorized Setra dealer for
the Setra Quick Count Technician's Guide, or request a copy from the
factory.
Setra Quick Count™ Operator's Manual
or 340P dot matrix
5 through 7 any
™
. Contact your local authorized Setra dealer
printer, use
time you wish
the following
to print out
13