Reverse Counting Or Kitting - Setra Systems Quick Count Operator's Manual

REVERSE COUNTING OR KITTING

Using this feature, you can place a container full of pieces on your
scale and count the number of pieces removed. This is especially helpful
when kitting (counting out a certain number of pieces to be packed
together). To perform reverse counting or kitting, use the following
procedure:
1. Place a container full of pieces you wish to count on the pan.
2. Press the zero key.
3. Press the sample size key.
4. The scale display will say " Add 10. PC" .
(The sample size requirement can be increased by pressing the
sample size key repeatedly. The predetermined sample sizes are: 10,
25, 50 and 100 pcs. This sequence of predetermined sample sizes
will repeat itself as the sample size key is pressed. A custom sample
size may be preset by using the minimum sample size setup feature.
If this is the case, the scale will never request a sample size
less than the preset minimum sample size.)
5. When you reach the desired sample size, REMOVE the requested number
of pieces from the container.
6. Press the count key. If the sample size is not large enough to
satisfy the minimum accuracy requirement the display will read
" Sub nnn" . Remove the specified number of pieces (i.e., nnn) from
the container and press the count key again.
7. Remove pieces until the display reads the number of pieces you wish
to count out or kit.
8. Press the zero key.
9. Repeat Steps 7 and 8 as many times as needed.
12 Setra Quick Count™ Operator's Manual