Appendix I; Set-Up Functions - Setra Systems Quick Count Operator's Manual

Your Setra Quick Count scale was programmed at the factory to operate in
a prescribed manner. Many of the factory settings can be altered by an
authorized Setra dealer to optimize scale performance for your counting
or weighing operation. For example, the scale is factory preset to
request a minimum of 10 pieces to initiate the counting process. Your
dealer can alter the minimum to a smaller or larger sample, such as 5 or
25 pieces. Your dealer can also alter the minimum counting accuracy, the
baud rate used for data communications, display hysteresis and print
formatting.
Factory settings can also be changed by a scale operator using a Setra
Auto Count ™ 200, or by using a computer connected to the scale through
the bi-directional RS-232 serial data port. For information on how to
use a PC to alter factory settings ask your dealer for the Setra Quick
Count Technician's Guide, or request a copy from the factory.
The following scale settings are available in addition to the factory
default settings. Your dealer may change these settings to fit your
particular application and so the factory defaults may not apply.
Minimum Sample Size(pieces):
25, 50 or 100
Minimum Counting Accuracy: 95-99.99%, none
Baud Rate:
2400
Parity:
parity
Display Hysteresis:
Printer Settings:
Print Device Type:
To print a copy of the scale's current setup information use the
following procedure. Connect the scale to a printer via the RS-232
serial port. Power up the scale and then hold the print key down while
the scale completes the countdown and displays the scale capacity, i.e.,
-2-, -1-, C nnnng. The scale will display " rEF n.n" , the software
version while printing the current setup information. Press the clear key
twice to return to the normal weighing mode.
14
300, 600, 1200, 2400, 4800, 9600 Default:
even/odd/none
on or off
Display hysteresis when enabled provides a
more stable, easier to read number. Display
hysteresis can be set to prevent the last
digit from changing if weight changes are
less than 1 displayed increment.
Default: Weight/Count,
Weight,
240P 340P
240P
340P with 6 line feeds for 1" length labels
Auto Count 200 - English/Bar Code
ScriptCoder - custom English/Bar Code designs
Setra Quick Count™ Operator's Manual

Appendix I

Set-Up Functions

0-999 Default: 10,
Default: 95%
no
Default: on
Average
English
Piece
Format,