Advertisement
Audio Failure Alarm
If no audio is applied to the Omnia
approximately twenty seconds after bo
Flr : Audio failure: left input
Flr : Audio failure: right inpu
Flr : Audio failure: left
Flr : Audio failure: right ou
In t
he absence of an audio sou
failu
re trigger level is –37.5dB
dete
ct algorithm to time out. It i
leve
l happens to fall below –37.
Au
dio Restoration Alarm
App
roximately five seconds
will
be seen:
Flr : Audio restored: left i
Flr : Audio restored: ri
Flr : Audio restored: left output
Flr : Audio restored: right output
Not
e that it is possible for there to be audio Output failure message
mea
ns that the unit is detecting a
From
the perspective of signal
This
is also where the input
Dia
gnostic and Erro
In t
he event that you need to contact Telos / Omnia Customer Support for assistance, please see the section
enti
tled Obtaining Service on Page 97 for contact information.
The
following error messag
Insufficient Memory! Sav
Description: This e
rror will occu
factory presets) on
the rear-panel PCMCIA card.
Cause: Too many presets are saved to the rear-panel software card.
Resolution: Delete a preset or two and then try the save operation again.
The following messages will only appear on the rear panel RS-232 Serial Port. See page 92 for instructions on
how to access the serial port messages.
Work: Insert card to continue!!!
Description: The operating system cannot see the rear-panel PCMCIA memory card.
Cause: The rear-panel PCMCIA card is missing or not fully seated.
Resolution: Turn the power off and make sure that the card is fully inserted into the top card slot with the large
Omnia label facing up and the version number sticker facing down. The PC Card is keyed to prevent improper
insertion. Gently
press the card into the slot until the black release button, to the right of the card, pops out about
1/2" [12.70 mm]. This indicates the card is properly seated in the PCMCIA slot. If the card is properly seated and
this error still appears, contact Telos / Omnia Customer Support for assistance.
, the following messages will be transmitted next on the RS-232 port,
ot up:
t
output
tput
rce, these "Audio failure" messages are normal. Note that the Omnia's audio
FS, and the signal must remain at or below that level in order for the silence
s possible to see these messages during normal programming if the audio input
5dBFS and remains there until the audio fail algorithm times out.
after audio has been restored to levels above –37.5dBFS, the following messages
nput
ght input
pplied audio at its Inputs, but that there is no output from the DSP chain.
flow, the Input meters follow the input level adjustment controls (Input Menu).
to the Input Audio Failure comes from.
r Messages
es will appear on the front panel screen:
e As Failed.
r when trying to save a new preset while there are already 50 presets (including
s but no audio Input failure message. This
94
Advertisement
